I did Installed HDS 3.102.004 and try to do ECM/PCM Replaced.But it not let me to do it.The HDS error message says “This function is deleted from HDS. When I upgrade my HDS i uninstall old version before I install the new than i unlock the IMMO again that is just my personal preference how i do that, but you dont need to unlock it each time you want to use it with each vehicle but if you upgrade HDS to a newer version in the future then probably yes. W hen i unlock the immobiliser is it permanent or do i have to do this for every car i connect to ? ( as I remember well )ītw, I always uninstall the old and do a fresh install of the new personally Firsr will unistall the installed version then you will need to start the installer again and it will install the new version. I-HDS will uninstall your old version and it will install after the new one. Has to be fresh installation or i can install it over my older version ? I added the IMMO to the download if you check it again it will be in there, It only works with HDS not iHDS, I have not tried it with this latest version though Need windows 7 for ihds and the j2534 program also HDS works but not ihds i am using windows xp sp3 i believe its a java error but sadly my java wont updateĭo not work on XP.
If you need to use ihds just install that 2nd over hds and j2534 just mount and install.
Just mount iso and click setup to install hds nothing else you need to do. T here are no install instructions and is this 圆4 or x86 Note: immo only works with hds so dont install ihds over hds if you want to use it Select “REPLACE ECM/PCM MENU”, then select “WRITE DATA”Ģ3) Manually enter the immobilizer ECM/PCM code that you got previously, and use the ECM/PCM replacement procedure in the HDS it allows you to start the engine.Ģ4) If the system fails to TP POSITION CHECK, clean the throttle bodyĢ5) If the system fails to READ DATA or WRITE DATA, replace the engine oil and the engine oil filter.Ģ6) Select the PGM-FI system, and reset the ECM/PCM with the HDS.Ģ7) Update the ECM/PCM if it does not have the latest software.Free Honda HIM HDS 3.102.051 iHDS 1.004.012 NOTE: ECM/PCM connectors A, B, and C have symbols (A=□, B=△, C=○) embossed on them for identification.ġ5) Install ECM/PCM in reverse order of removalġ7) Enter the VIN which already actually calculated by HDS IMMO VIN Code calculator to ECM/PCM.ġ8) Select “PGM-FI” system in HDS programġ9) Select “REPLACE ECM/PCM MENU”, then select “WRITE DATA”Ģ1) Repeat Step 20). 14) Disconnect ECM/PCM connectors A, B, and C, then remove the ECM/PCM (F).
0 kommentar(er)
